12-tube controller is not powerful enough?
In freight scenarios, traditional Electric Tricycle controllers often show shortcomings due to the limited number of tubes: the power of the Electric Tricycle Motor "decreases sharply" when overloaded, and the response of the electric tricycle Rear Axle is delayed under complex road conditions, and even drags down the endurance performance of the Electric Four-wheel Vehicle. Drivers complained: "The 10-tube controller pulls half a ton of cargo to climb the bridge, the motor shakes and the controller flashes wildly!"
Our 12-tube Electric Motor Controller breaks the game with "multi-tube drive + intelligent adaptation"! The 12-tube power module works together to increase the power by 30% compared to the traditional 10-tube controller. With the cross-model adaptation system, the electric three-wheel/four-wheel drive mode can be switched with one click. Actual measurements show that when climbing a 15° slope with a load of 800 pounds, the motor speed stability is increased by 50%, and the rear axle wear rate is reduced by 60%. Feedback from a courier in Shenzhen: "After changing to 12 controllers, we can load 200 more pounds per trip and run 2 more delivery points every day!" Three core advantages
① Multi-tube parallel drive: 12 tubes synchronously control the current, the starting torque reaches 85N·m, and there is no jamming under heavy load;
② Cross-model intelligent adaptation: compatible with three-wheel/four-wheel models, dial code to switch the drive mode, and the power matching accuracy is 98%;
③ Temperature control and waterproof double protection: 70℃ automatic frequency reduction protection + IP65 waterproof shell, wading in the rainy season does not affect operation.
Practical maintenance tips
1. Tube number balance detection: Use a multimeter to check the 12-tube voltage every month (deviation ≤0.5V) to prevent single-tube overload;
2. Vehicle switching calibration: After changing the three-wheel/four-wheel mode, road test 5 kilometers to optimize the motor parameters;
3. Heat dissipation and waterproof maintenance: clean the heat dissipation holes every week, replace the sealing ring before the rainy season to prevent mud clogging.
