The motor suddenly "burps" when climbing a slope, the controller goes into water and stops working during heavy rain, and the Rear Axle makes abnormal noises frequently when overloaded - these problems caused by the insufficient performance of the Electric Tricycle controller are giving countless freight masters a headache. The traditional controller is like the "short board barrel" of the power system: inefficient current control makes the Electric Tricycle Motor unable to exert its power, poor heat dissipation causes high temperature shutdown, and it cannot form an efficient linkage with the electric tricycle rear axle, which directly drags down the freight efficiency.
Our high-performance electric tricycle controller is the core solution to solve the power dilemma! It uses a military-grade vector control chip, which can accurately allocate the motor power like an "intelligent commander": the current is output smoothly when starting without colliding with the car, the torque is automatically increased by 30% when climbing, and kinetic energy can be recovered to charge the battery when going downhill. With a fully sealed waterproof shell (IP67 protection level) and an intelligent cooling system, the controller temperature can be kept below 60°C even when climbing continuously in heavy rain. The actual test shows that the motor efficiency is increased by 45% and the rear axle gear wear is reduced by 60%. A courier from Guangdong reported: "I used to have to get off the car to push the bridge, but now I can just go up with a full cargo box, and run 5 more orders a day!"
Three hardcore features
① Power precision control brain: real-time monitoring of motor speed and torque requirements, millisecond-level adjustment of current output, and 50% increase in power response speed when loaded;
② All-weather protection shield: waterproof guide groove + cooling fin design, can wade directly through rainy days, and work continuously for 8 hours without downtime in high temperature environment;
③ Rear axle coordination system: data linkage with the rear axle gear, automatic motor speed limit when overloaded, to avoid excessive gear wear.
Maintenance tips from veteran drivers
1. Waterproofing is a must: wipe the controller connection port with a dry cloth after rain, and check the sealing ring for aging every month;
2. The golden rule of heat dissipation: stop the car for 3 minutes after continuous heavy load to dissipate heat, and do not let mud block the heat dissipation holes of the controller;
3. Data calibration technique: use special equipment to calibrate the controller parameters every 5,000 kilometers to ensure that the motor and rear axle are always "in sync".
