Is it difficult to load goods when climbing a slope?
When a fully loaded Electric Tricycle "breaks down" in front of a bridge slope, when the controller alarm sounds frequently when overloaded, when abnormal noises from the Rear Axle appear along with the motor's lack of power - these difficulties caused by insufficient power of the Electric Tricycle Motor are making freight masters miserable. Traditional motors are like "sick hearts": inefficient torque output makes it impossible for the Electric Tricycle Controller to accurately allocate power, and the weak electric tricycle rear axle is even more difficult to withstand the impact of heavy loads, which ultimately leads to the transportation dilemma of "unable to pull, climb, and run far".
Our high-efficiency, high-torque electric tricycle motor kit is the core solution to solve the power dilemma! It uses a 2800W rare earth permanent magnet motor with an intelligent vector controller, and its torque output is 60% higher than that of traditional motors. With the reinforced rear axle gear set, it forms a "power golden triangle": when climbing a slope, the controller automatically optimizes the current output, the motor instantly bursts out strong torque, and the rear axle simultaneously enhances its load-bearing capacity. Actual tests show that when a tricycle equipped with this kit is loaded with 800 catties and climbs a 20° slope, the power response speed is increased by 50%, and the abnormal noise problem of the rear axle is reduced by 70%. A seafood vendor in Fujian reported: "In the past, it took two people to push the goods across the ramp at the dock in the early morning. Now I can go up directly with one foot on the ignition, and I go to the seafood market twice more every day!"
Three hard-core features
① Torque burst system: The motor adopts a six-pole magnetic steel design, and the instantaneous torque of starting can reach 85N·m, and there is no slipping when starting with heavy load;
② Intelligent collaborative chip: The controller and the motor are linked with real-time data, and the power is automatically adjusted according to the load, and the energy consumption is reduced by 35% compared with traditional kits;
③ Rear axle reinforcement components: thickened gear + double-row bearing design, the load-bearing capacity is increased to 1000kg, suitable for various heavy-load scenarios.
Maintenance tips for veteran truck drivers
1. Check the three components: Use a multimeter to check the wiring voltage between the motor and the controller every week, and replace the rear axle gear oil every 2,000 kilometers;
2. The golden rule for heat dissipation: After continuous heavy loading, stop the truck for 5 minutes and use compressed air to clean the mud in the motor heat dissipation holes;
3. Load balancing technique: Move the center of gravity of the cargo back 15 cm to avoid overloading the motor, and the load difference on both sides of the rear axle should not exceed 10%.
